# dmesg Linux version 2.6.12.5 (root@localhost.localdomain) (gcc version 3.4.6) #3 Fri May 7 17:00:44 CST 2010 CPU: ARM926EJ-Sid(wb) [41069265] revision 5 (ARMv5TEJ) CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets CPU0: D cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets Machine: ORION Memory policy: ECC disabled, Data cache writeback On node 0 totalpages: 16384 DMA zone: 16384 pages, LIFO batch:7 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 Built 1 zonelists Kernel command line: root=/dev/mtdblock/5 rw rootfstype=jffs2 console=ttyS0,115200 mem=64M mtdparts=phys_mapped_flash:448k(u-boot)ro,128k(loader1)ro,128k(loader2)ro,2048k(kernel),-(fs);ORION:-(Part01) ethaddr=00:1A:CC:01:xx:xx ORION Readed MAC:00:1a:cc:01:xx:xx PID hash table entries: 512 (order: 9, 8192 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 64MB = 64MB total Memory: 61568KB available (2471K code, 643K data, 108K init) Calibrating delay loop... 107.72 BogoMIPS (lpj=538624) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 SCSI subsystem initialized Linux Kernel Card Services options: none usbcore: registered new driver usbfs usbcore: registered new driver hub NetWinder Floating Point Emulator V0.97 (extended precision) devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x0 NTFS driver 2.1.22 [Flags: R/O]. JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc. fb0: ORION frame buffer @[0xec00000, 0xc4880000] size 0x1400000 fb1: ORION frame buffer @[0xe000000, 0xc5d00000] size 0xc00000 ORION GPIO at 0x101e4000, 16 lines ORION GPIO2 at 0x10260000, 55 lines Smart card: base address 101f0000 map to c4866000 Orion Watchdog Timer: timer margin 40 sec Xport: Init OK [0x0d900000]. orion_video: Orion Video driver was initialized, at address@[phyical addr = 41600000, size = 100000] csdrv audio init ok ... Default ORION I2C at 0x10170000, 100KHZ orion15_df: Orion Display feeder driver was initialized, at address@[phyical addr = 41800000, size = 1000] orion15_df: Orion TVE0 driver was initialized, at address@[phyical addr = 10168000, size = 1000] orion15_df: Orion TVE1 driver was initialized, at address@[phyical addr = 10160000, size = 1000] pinmux0 : 0x0, pinmux1: 0x1001 dma_pool_alloc: dma_phy_addr: 3d31000, ttx_buf: ffc00000 Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled ttyS0 at MMIO 0x101f1000 (irq = 12) is a 16550A ttyS1 at MMIO 0x101f2000 (irq = 13) is a 16550A io scheduler noop registered io scheduler anticipatory registered RAMDISK driver initialized: 1 RAM disks of 16384K size 1024 blocksize loop: loaded (max 8 devices) ORION eth0: 0x41400000 IRQ 24 MAC:00:1a:cc:01:xx:xx Not SST flash.<5>physmap flash device: 800000 at 34000000 phys_mapped_flash: Found 1 x16 devices at 0x0 in 16-bit bank Amd/Fujitsu Extended Query Table at 0x0040 number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. 5 cmdlinepart partitions found on MTD device phys_mapped_flash Creating 5 MTD partitions on "phys_mapped_flash": 0x00000000-0x00070000 : "u-boot" 0x00070000-0x00090000 : "loader1" 0x00090000-0x000b0000 : "loader2" 0x000b0000-0x002b0000 : "kernel" 0x002b0000-0x00800000 : "fs" NAND device: Manufacturer ID: 0xec, Chip ID: 0x76 (Samsung NAND 64MiB 3,3V 8-bit) Bad block table found at page 131040, version 0x01 Bad block table found at page 131008, version 0x01 Using command line partition definition Creating 1 MTD partitions on "ORION": 0x00000000-0x04000000 : "Part01" PCMCIA: orion_pcmcia_init called! Succesefully create pcmcia proc entry! orion socket ci module initializing!!! Initializing USB Mass Storage driver... usbcore: registered new driver usb-storage USB Mass Storage support registered. usbcore: registered new driver usbhid drivers/usb/input/hid-core.c: v2.01:USB HID core driver drivers/usb/musb/musb_driver.c: Initializing MUSB Driver [npci=1][gadget=no][otg=no] MUSB Drive version 1.1.0.1 mgc_controller_init: Driver instance data at 0xc3d42400 mgc_hdrc_init: MHDRC version 1.500 info: UTMI-8, dyn FIFOs, SoftConn mgc_controller_init: End 00: FIFO TxSize=0040/RxSize=0040 mgc_controller_init: End 01: Shared FIFO TxSize=0200/RxSize=0200 mgc_controller_init: End 02: FIFO TxSize=0000/RxSize=0040 mgc_controller_init: End 03: Shared FIFO TxSize=0400/RxSize=0400 mgc_controller_init: New bus @0xc3d21760 musb-hcd usb0: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected NET: Registered protocol family 2 IP: routing cache hash table of 512 buckets, 4Kbytes TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 Root-NFS: No NFS server available, giving up. VFS: Unable to mount root fs via NFS, trying floppy. jffs2_scan_inode_node(): CRC failed on node at 0x020609c4: Read 0xffffffff, calculated 0xd5c34c81 Empty flash at 0x0349d41c ends at 0x0349d600 VFS: Mounted root (jffs2 filesystem). Freeing init memory: 108K Warning: unable to open an initial console. jffs2_get_inode_nodes(): Data CRC failed on node at 0x0349d3a8: Read 0xfba74207, calculated 0xbafe0fe2 ORION eth0: MII transceiver 1 status 0x786d advertising 01e1. eth0: link up, 100Mbps, full-duplex, lpa 0xCDE1 loading xport firmware readed xport fw data section size =240 readed xport fw text section size =10872 loded xport firmware --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50 loading xport firmware readed xport fw data section size =240 readed xport fw text section size =10872 loded xport firmware --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50 --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50 --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50 --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50 --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50 --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50 --CSVID_IOC_SET_STARTDELAY-- Delay Time = 50